• Simple and rapid installation
• Easily learns the codes of wireless devices (up to 20) and associates them to INSTEON groups
• FSK narrowband, multiple-conversion, long-range (up to 3,000 ft.) receiver with 12-bit codes (up to 4,096 unique codes)
• Large INSTEON links database able to contain more than 256 INSTEON linked devices
• Sends an INSTEON ON group command when a code is detected, and an OFF command when the signal turns off. Timers from .5 to 15.5 minutes can be set to delay the OFF command
• INSTEON commands can be altered with home automation software packages
• Acts as a repeater of powerline INSTEON signals
• 2-way communications for high reliability
• Pass-through outlet may be used for other appliances
• 1-year warranty by SimpleHomeNet

Your EZSnsRF receiver can pick up signals transmitted by companion transmitters from up to 3,000 ft. All of Dakota Alert's Series 3000 transmitters are compatible and can be used immediately to form a long range network of alarms to trigger actions on Insteon devices.

A common use is for driveway alarms, where the detection of a vehicle can put in motion a chain of events such as turning on a set of lights and sounding a unique chime. Another use is as a panic alarm where multiple devices such as a siren or a telephone dialer can be activated in response to a user pushing a button on a Dakota Alert transmitter.

EZSnsRF makes possible the creation of Insteon events by alarms from multiple wireless sensors.

INSTEON compatibility means virtually unlimited connectivity, including wireless networks and the Internet.

EZSnsRF is easy to install and operate, and it is ready out-of-the-box to distinguish up to 20 uniquely coded wireless devices.

Our partnership with Dakota Alert immediately opens the use of your EZSnsRF to solve real problems in long and short range situations.

Please refer to the quick-setup guide that comes with your EZSnsRF for detailed installation instructions. This quick-guide is also available from the free downloads section. Your EZSnsRF is easy to use and its operation does not require a home automaton software package. However, as part of the growing family of Insteon-enabled products, your EZSnsRF will be supported by home automation programs such as HouseLinc from Smarthome, mControl from HomeSeer Technology or Indigo from Perceptive Automation. The command set documentation is also available from the downloads area

General
SimpleHomeNet Product Number	EZSnsRF, Wireless Sensor Receiver; Model #5010E
Warranty	1 year
Channels (distinct codes)	20 total, each one defaulting to a unique Insteon group number 1-20
Insteon Device Links	Up to 256. Each group can have multiple devices
Operation
Status LED	White or Blue
Setup Memory	Non-volatile EEPROM
INSTEON Features
INSTEON Addresses	1 hard-coded out of 16,777,216 possible
INSTEON Links	30
INSTEON Powerline Frequency	131.65 KHz
INSTEON Minimum Transmit Level	3.2 Vppinto 5 Ohms
INSTEON Minimum Receive Level	10 mVppnominal
INSTEON Messages Repeated	Yes
Mechanical
Operating Conditions	Indoors, 32 to 122°F, up to 85% relative humidity
Dimensions	4.0" H x 2.5" W x 1.5" D (excluding external valve connector)
Weight	5 oz
Electrical
Supply Voltage	120 Volts AC +/- 10%, 60 Hertz, single phase
Surge Protection	MOV rated for 150 Volts
Power Plug	3-pin grounded
Pass-through Outlet	3-pin grounded
Certification	Safety tested for use in USA and Canada (ETL #3101636)

Input/Output (Control/Monitor I/O) Downloads
EZSNSRF Quick Set-up Guide		Instructions on EZSnsRF set-up
EZSnsRF Command Set		Command Set and Memory Map to support applications development